Print bed raised in the middle

My Aquila X2 H32 worked great for about a month and a half, but now I have an issue.

Short series of events.

Had a clog randomly for the first time, had to replace the bowden tube because it was that stuck, used a new capricorn one. Had to take off the hotend from the mount, reinstalled it, noticed the whole mount was loose, tightened it. I levelled it one more time then went to print and thats where i met my issue. I had just bought silicone mounts instead of springs so installed them and tried again, to no avail. I put the springs back on and still no progress there.

My print bed seems to be raised in the middle and I'm not sure what to do about it. I levelled the bed about 20 times, and come up with the issue still. I have a magnetic bed and I tried elevating the 4 corners with small pieces of masking tape, but it didn't seem to help much.

It seems like it is warped, and I'm not sure what to do about it. I took it off entirely and ran a ruler across and it seems to have gaps at either edge.

Any ideas or suggestions would be greatly appreciated